Author Topic: Using new Function Node  (Read 6607 times)

Offline andersrm

  • Newbie
  • *
  • Posts: 19
    • View Profile
Using new Function Node
« on: February 23, 2013, 03:44:06 »
I would like to compute a utility based on the difference between two discrete chance interval nodes.  My understanding is that this CANNOT be done with real-valued function nodes at present since these cannot accept interval nodes as parents.  Any other suggestions on how to do this?  Other than representing the difference as a discrete chance interval node and assigning a discrete utility to each of its states..  Even if I could use a function node, and wanted to assign a utility node as a child, that utility node I suppose could only handle discrete values...

Offline Anders L Madsen

  • HUGIN Expert
  • Hero Member
  • *****
  • Posts: 2282
    • View Profile
Re: Using new Function Node
« Reply #1 on: February 28, 2013, 19:35:45 »
It is correct that the value of a function node cannot be computed from an interval nodes. The states of an interval nodes represents a range of values and it is not possible to compute the value of a child function node.

In principle, you could add a utility node as the common child and define an expression for its table as the difference between the two parents. Alternatively, you could as a rough approximation add a numbered node as child of the interval nodes and use a function node to compute the difference between the numbered nodes.
HUGIN EXPERT A/S